Hold the cylinder and ring 1 as shown in the figure. Line up the cutout and the hole, and place it through the cylinder.

---

After passing through to the height of the stopper, rotate ring 1 to the right until it clicks. Make sure there is a partition in the middle of the ball passage.

---

As shown in the figure, align bump A on ring 2 to the goal hole and turn it to the left until it clicks. Make sure the position of the flag is at the back as shown in the figure.

---

Attach it so that the large protrusion on the back of the roof matches the position of the slot.

---

Hold the main unit firmly, and insert the 2 grips into the holes on the left and right. If the grip does not fit properly, make sure that the protrusion under the grip is aligned with the cutout hole.

---

Attach the bottom part to the back of the main unit.

---

Attach the 3 gimmick parts to the position shown in the figure. Finally, attach the castle tower by turning it into the center. The castle tower will fit into one step down when it is in the correct position.